New gasket will not fix it.
You need the head rebuilt and skimmed, as liner %26quot;chattering%26quot; causes a ridge in the head which a new gasket will not seal either.
There is a guy in Kent ( G Wood Engineering) who can machine the head and fit ring inserts into it where the gasket mates to the cylinder head and block. Head is then machined flat and with a new gasket hey presto, it works.
Also check the liners haven't moved and popped the seals in the block, as it is a common problem after head removal.
Never %26quot;lift%26quot; the head off, always twist so as not to pull the liner off the seal, otherwise it's an engine strip.Rover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?well to start out the head gasket is blowen agin and if this has happend two times now it is going to need a new header to or u will blow the hole motor this will probly cost more money then u thought but once it is done then u will have to get an oil flush and changed and a raditore flush also then new flueid after this the car should run like a topRover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?Sorry, but it's the head gasket again.
Google on K series head gaskets and you will find out more than you ever wanted to know about this serial weak spot.Rover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?gasket poss head warped did you get the modified land rover h/gasket fitted
seen these guys recommended before sound like they may be what your looking forhttp://www.head-mechanics.co.uk/Rover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?You have a head gasket blown without a doubt , If the head wasn't skimmed or tightened down correctly this can keep happening.Rover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?Its either the head gasket or intake manifold gasket (not sure) but for one thing, if you keep driving it, the antifreeze mixed with the oil will destroy all your bearings (if it hasn't already.)Rover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?OOOOPS! The engine is scrap! looks like it would be cheaper for you to get a fully reconditioned engine as the head is possibly warped due to overheating. If you decide to have the original engine 'done' I would suggest you also have the top surface of the block skimmed - often overlooked - as there could be 'pitting' where water has leaked from the channels. A very common fault on the 'smaller' capacity K series petrol engines. Good for about 60k miles before you get trouble.Rover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?head gasket has gone again the most common thing on the rovers especially on the k series enginesRover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?Head Gasket again?Rover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?sounds like head gasket again unfortunately
could try a complete gasket kit but sounds like you've got water in the systemRover200 keeps losing power, oil is creamy, water drunk in minutes, over rev'ing, cant use car. any1 help?Looks like the same again and the %26quot;head gasket%26quot; has gone again%26quot;.
